SER1 FW: Mixture Cable (Choke)

[prev] [thread] [next] [Date index for 2004/10/11]

From: "Mattd68" <matt.draysey@xxxxxx.xx.xx>
Reply-To: "The Series One Garage" <TheSeriesOneGarage@xxxxxx.xxx.xxx>
To: "The Series One Garage" <TheSeriesOneGarage@xxxxxx.xxx.xxx>
Subject: Mixture Cable (Choke)
Date: Mon, 11 Oct 2004 05:27:25 -0700


Hi all

I had to use the mixture control (choke cable for the first time on my 
recently acquired 1956 86" SI, and have found that it is broken!

I have take the unit apart and cannot see how the cable is attached to the 
pull-knob?

I found in my workshop an old Series III diesel stop cable, that appears to 
have a roll pin holding the cable in place, on the SI the cable is a solid 
wire and there appears to be no roll pin in the hole!!

So am I right in saying that the mixture control (choke) cable is not a 
cable but a solid wire held in place in the pull-knob by a small roll pin?

I hope this make some sense, and hope some one can help as the part is no 
longer available!

Cheers
Matt



-----------------------------------------------------------

To stop getting this e-mail, or change how often it arrives, go to your 
E-mail Settings.
http://groups.msn.com/TheSeriesOneGarage/_emailsettings.msnw

Need help? If you've forgotten your password, please go to Passport Member 
Services.
http://groups.msn.com/_passportredir.msnw?ppmprop=help

For other questions or feedback, go to our Contact Us page.
http://groups.msn.com/contact

If you do not want to receive future e-mail from this MSN group, or if you 
received this message by mistake, please click the "Remove" link below. On 
the pre-addressed e-mail message that opens, simply click "Send". Your 
e-mail address will be deleted from this group's mailing list.
mailto:TheSeriesOneGarage-remove@xxxxxx.xxx.xxx



To change subscription see www.landrover.net/series1/mail