Re: SER1 door capping rivetts

[prev] [thread] [next] [Date index for 2005/04/05]

The rivets are available from various sources- they are 3/16 inch round  or flat
head rivets.  It is important to get the right length.  The best source is
probably Keith Wadsworth , who will also sell you the correct punches that are
used with an air chisel.  You need to practise on one or two first.

Tom Christie.

Bob Phillips wrote:

> Hi,
>
> Have started to remove the door top cappings and the cappings from the rear
> body.
> These will then be sent for re galvanizing.
>
> Have removed all of the rivets, what I would like to know is, what the domed
> type rivets are called and what tool is required to fit these.
>
> I have a pop riveter for the side rivets, but not the top rivets, as this
> looks like they must be fitted with a different type of tool.
>
> Advice on these would be most welcome.
>
> Bob
>
> To change subscription see www.landrover.net/series1/mail




To change subscription see www.landrover.net/series1/mail