Re: SER1 starter field coils and brushes

[prev] [thread] [next] [Date index for 2005/06/20]

It's not possible to put the series 2 starters on the 2.0L engine?

Thanks,
Ian

On 6/19/05, Jonathan Merz <jonathanmerz@xxxxxxx.xxx> wrote:
> Starter brushes will depend on which starter model you have.  I had a Lucas
> M418G starter on my '57 2 litre and rebuilt it and installed it on my late
> 2.25 retrofit.  I assume that the late series 1 starter was the same as
> early series 2.  I do know that the later series 2 Lucas GEU419 starter does
> not share the same brushes as the M418G.
> I do not know how this may apply to earlier series 1 starters.  The Lucas
> model number should be stamped quite clearly onto the case of the starter
> itself.  The model number will be the best help in tracking down brush
> replacements.  I found that the solderings needed a strong and minute source
> of heat to remove them quickly to avoid damaging the windings and
> insulation.  I found a miniature torch worked well when used with great care
> for desoldering and installation of new brushes.
> 
> Hope this can be of help,
> 
> Jon Merz
> '58, 88" Ex DOT
> BC, Canada
> 
> 
> 
> To change subscription see www.landrover.net/series1/mail
> 
> 


        -- 
        Ian N. Balcom
PhD Student
Environmental Toxicology Department
University of California
Riverside CA  92521
909.380.2176


To change subscription see www.landrover.net/series1/mail