Re: SER1 starter field coils and brushes

[prev] [thread] [next] [Date index for 2005/06/20]

Starter brushes will depend on which starter model you have.  I had a Lucas 
M418G starter on my '57 2 litre and rebuilt it and installed it on my late 
2.25 retrofit.  I assume that the late series 1 starter was the same as 
early series 2.  I do know that the later series 2 Lucas GEU419 starter does 
not share the same brushes as the M418G.
I do not know how this may apply to earlier series 1 starters.  The Lucas 
model number should be stamped quite clearly onto the case of the starter 
itself.  The model number will be the best help in tracking down brush 
replacements.  I found that the solderings needed a strong and minute source 
of heat to remove them quickly to avoid damaging the windings and 
insulation.  I found a miniature torch worked well when used with great care 
for desoldering and installation of new brushes.

Hope this can be of help,

Jon Merz
'58, 88" Ex DOT
BC, Canada



To change subscription see www.landrover.net/series1/mail