Re: SER1 Minerva Wiring

[prev] [thread] [next] [Date index for 2005/10/04]

George,

The original wiring of the Minerva was made of plastic coated copper, 
all the wires colored yellow ;-( except some wires in the “cockpit housing”.

Do you have any Minerva books?
In the “handleiding” (= manual) is a wiring schematic, but the wires are 
numbered and not color coded…….;-(
The same schematic is also in the “handleiding voor onderhoud” (= manual 
for maintenance) and in the “organieke maintenance,”( workshop manual?) 
witch also contains a explanation of the numbers in the wiring schematic.

I hope this helps a bit,

Coen


George E Sollish wrote:

> Bit of exotica for most, but I'm hoping one of our Minerva owners has 
> an original loom or a color-coded wiring diagram :-)
>
> Can anyone advise the correct color/trace for the following wires in 
> the Minerva turn signal harness?
>
> Control Box 'E' post to Flasher post (1)
>
> Flasher post (1) to Switch post (1)
>
> Flasher post (2) to Switch post (3)
>
> Flasher post (3) to Fuse Box
>
> Switch post (2) to Bulkhead Junction (left)
>
> Bulkhead Junction (left) to Front Signal Lamp (left)
>
> Bulkhead Junction (left) to Trailer Junction (left)
>
> Trailer Junction (left) to Rear Signal Lamp (left)
>
> Switch post (4) to Bulkhead Junction (right)
>
> Bulkhead Junction (right) to Front Signal Lamp (right)
>
> Bulkhead Junction (right) to Trailer Junction (right)
>
> Trailer Junction (right) to Rear Signal Lamp (right)
>
> Thanks.
>
> George E Sollish Chief Engineer Auto Gear Equipment
> Project Manager The Payne Lake Project
>
> To change subscription see www.landrover.net/series1/mail
>
>
The original wirering

To change subscription see www.landrover.net/series1/mail