RE: SER1 clutch alignment

[prev] [thread] [next] [Date index for 2005/06/01]

The tool is basically a shaft of about 5" length with a diameter of 0.910"
( 23 mm ) The first inch is stepped down to o.875" ( 22mm).
The smaller bit fits into the fly wheel center and the clutch plate fits
over the larger diameter.
You can make one ( or have one made) out of a variety of materials, brass,
steel , hardwood ( Broomhandle!!) plastic et c.
Sometimes You can find a deep socket in Your toolkit with the right
dimensions. In a pinch You can use a screw driver handle suitably buttered
up with masking tape (how does he know, You ask) or stacked washers on a
long bolt.
Be creative!
I wonder what other tinkeres have used? List? anyone??
Tom T


-----Original Message-----
From: series1-host@xxxxxxxxx.xxx [mailto:series1-host@xxxxxxxxx.xxx]On
Behalf Of Ian Balcom
Sent: June 1, 2005 3:20 PM
To: series1@xxxxxxxxx.xxx
Subject: SER1 clutch alignment


I cannot find an alignment tool for the clutch..
Is there another way to align the clutch without the tool?


thanks,
Ian
'55 86"


To change subscription see www.landrover.net/series1/mail


To change subscription see www.landrover.net/series1/mail