Re: SER1 Paddocks Swivel kits

[prev] [thread] [next] [Date index for 2005/06/16]

I used one on my 1953 (tracta joint type) - but with the addition of  
the non railko type bits bought separately .  Seems fine in use - all  
fitted well  and worked out cheaper than replacing all the individual  
bits. I've no idea if it is any good for the later axle but my  
assumption would be that these are closer to Series II so it should be  
ok.


Note that the wheel/hub bearings are available from paddocks too - I  
bought these and again were fine.

  Jon
On 16 Jun 2005, at 10:07, Mark Strangways wrote:

> Hi all,
>
> Does anyone know if the following swivel kit from Paddocks will be ok
> with a 1957 axle? I think it probably will, but wanted to check first.
>
> "Swivel housing kit (early type with steering arm on the top) -
> consists of swivel housing (chrome ball), kingpin/bracket,
> railko/washer, bottom bearing, lock tabs/shims, swivel seal and all
> gaskets."
>
> Cheers
> Mark
> Halifax UK
>
> To change subscription see www.landrover.net/series1/mail
>
>
>
------------------------------------------------------------------------ 
---
We are now implementing a new ticketing system to improve response time  
and
reduce the chances of a request being missed. This does mean a change of
email address, but will help us to help you more efficiently. In future  
we
ask that new job requests be sent to nsmsjobs@xxxx.xx.xx.xx and general
queries/discussions to nsms@xxxx.xx.xx.xx.

Thanks for your cooperation - the NSMS Team.
------------------------------------------------------------------------ 
----


To change subscription see www.landrover.net/series1/mail