Re: AW: SER1 Diff pinon gauge

[prev] [thread] [next] [Date index for 2005/09/19]

Ulrico,
Are the two height blocks in your drawing for the two
different ratio diffs mentioned in the workshop
manual. i.e. one block for the 4.88:1 ratio diff and
the ther for the 4.7:1 diffs?
Cheers Charlie
--- Ulrico Becker <ulrico.becker@xxxxxx.xx> wrote:

> I have just made a set. The bar is exactly 3" (76.20
> mm) in diameter and the
> two height blocks are 38,10 and 38,15 mm high
> 
> Ulrico
> 
> -----Ursprüngliche Nachricht-----
> Von: series1-host@xxxxxxxxx.xxx
> [mailto:series1-host@xxxxxxxxx.xxx] Im
> Auftrag von charlie myres
> Gesendet: Sonntag, 18. September 2005 11:32
> An: series 1 mail list
> Betreff: SER1 Diff pinon gauge
> 
> Does anyone know what the dimensions for the special
> gauge Pt No. 262761
> are? I am reassembling the rear axle and if I can
> find out the dimensions, I
> can make one on the lathe.
> Cheers Charlie
> 
> 
> 		
> ____________________________________________________
> Do you Yahoo!? 
> Messenger 7.0: Free worldwide PC to PC calls
> http://au.messenger.yahoo.com
> 
> To change subscription see
> www.landrover.net/series1/mail
> 
> 
> 
> To change subscription see
> www.landrover.net/series1/mail
> 
> 


Send instant messages to your online friends http://au.messenger.yahoo.com 

To change subscription see www.landrover.net/series1/mail