Re: SER1 Swivel pin bearing housings for 1951 S1 80

[prev] [thread] [next] [Date index for 2005/11/19]

Karen,
I have a right side swivel with the tracta joint and axle still in it that 
I won't be using. Later today ( can check the swivel ball condirion.
I believe it was good. It's from a 51.
Bob B

At 01:04 AM 11/17/2005, you wrote:
>Does anyone know where I can acquire a pair of new or good condition 
>swivel pin housings P/N 217282 for my 1951 S1 80 (LHD North American 
>spec)? Mine may need polishing and rechroming which in my area is very 
>expensive. My S1 still has the cone bearing and seat for the swivel pin 
>and tracta joints.
>
>Alternately could I switch to the cone bearings and the swivel pin housing 
>from a later model such as a SII or early SIIA? Would the tracta joint 
>still fit?
>
>I appreciate any help because I have to decide soon to keep the 
>restoration going.
>
>Karen Sindir
>
>
>
>To change subscription see www.landrover.net/series1/mail



To change subscription see www.landrover.net/series1/mail