Re: SER1 Swivel pin bearing housings for 1951 S1 80

[prev] [thread] [next] [Date index for 2005/11/23]

Thank you Bob, you are so thoughtful. Let me know what condition they are in.  I was asking to see if anyone had a good original S1 pair available, or failing that, replacing them with the later model ones. I am leaning toward the second option as they look the same externally and apparently the S1 parts fit inside. 

Regards,

Karen
---- Bob and Sue Bernard <bobbnsueb@xxxxxxxxx.xxx> wrote: 
> Karen,
> I have a right side swivel with the tracta joint and axle still in it that 
> I won't be using. Later today ( can check the swivel ball condirion.
> I believe it was good. It's from a 51.
> Bob B
> 
> At 01:04 AM 11/17/2005, you wrote:
> >Does anyone know where I can acquire a pair of new or good condition 
> >swivel pin housings P/N 217282 for my 1951 S1 80 (LHD North American 
> >spec)? Mine may need polishing and rechroming which in my area is very 
> >expensive. My S1 still has the cone bearing and seat for the swivel pin 
> >and tracta joints.
> >
> >Alternately could I switch to the cone bearings and the swivel pin housing 
> >from a later model such as a SII or early SIIA? Would the tracta joint 
> >still fit?
> >
> >I appreciate any help because I have to decide soon to keep the 
> >restoration going.
> >
> >Karen Sindir
> >
> >
> >
> >To change subscription see www.landrover.net/series1/mail
> 
> 
> 
> To change subscription see www.landrover.net/series1/mail
> 


To change subscription see www.landrover.net/series1/mail