Re: SER1 Hi Low gear change

[prev] [thread] [next] [Date index for 2004/11/04]

Hi,
The rods that shift Low & High pass through the front of the transmission
and they corrode and get out of alignment and jit stiff.. Take off the cover
and clean them and you will find thing will move a lot easier. Peter.
----- Original Message ----- 
From: "Tom Wykes" <tw@xxxxxxxxxxxxxxxxxx.xxx>
To: <series1@xxxxxxxxx.xxx>
Sent: Wednesday, November 03, 2004 6:13 AM
Subject: Re: SER1 Hi Low gear change


>
> George.
>
> I'm probably telling you what you already know, so I apologize if this is
> the case. On the Minerva there may not be the "how to" plate fitted.
>
> If you press the yellow knob down to select 4 wheel drive in high range.
> The way to release it, is to select low range with the red knob and then
> push it back in to high range. The yellow knob should pop up on it's own.
>
> Like I said, if you knew this then ignore me.
>
>
>
>
> At 22:21 02/11/2004, you wrote:
> >Hi Alyn,
> >
> >No advice at present, but I have the same problem on my TT -- if I shift
> >into 4x4 it takes removal of the flooring, a major screwdriver and about
> >45 minutes to return it to 4x2.  I will report what I find if no one else
> >does so first.
> >
> >George E Sollish        Chief Engineer          Auto Gear Equipment
> >                         Project Manager         The Payne Lake Project
> >
> >On Tue, 2 Nov 2004, Alyn Fendley wrote:
> >
> > > Date: Tue, 2 Nov 2004 22:01:20 -0000
> > > From: Alyn Fendley <alyn.fendley@xxxxxxxxxx.xxx>
> > > Reply-To: series1@xxxxxxxxx.xxx
> > > To: series1@xxxxxxxxx.xxx
> > > Subject: SER1 Hi Low gear change
> > >
> > > Hi All
> > >
> > > I need some advice about the hi low gear change. It has become
increasingly
> > > difficult to move to low range to the point that I cannot get the
shaft to
> > > move back. Anyone had this prblem and know of a simple(!) fix. I'm
hoping
> > > that it's an adjustment thing rather than something inside.
> > >
> > > In my previous LRs there has never been a problem.
> > >
> > > Regards
> > >
> > >
> > > Alyn 1955 S1 (currently without low range)
> > >
> > >
> > >
> > > To change subscription see www.landrover.net/series1/mail
> > >
> > >
> > >
> > >
> >
> >To change subscription see www.landrover.net/series1/mail
>
>
> Regards.
>
> Tom Wykes.
>
>
>
> PCB Designer
> Cambridge Broadband.
> Tel.+44 (0)1223 703000
> Fax.+44 (0)1223 703001
> DDI. +44 (0)1223 703044
> tw@xxxxxxxxxxxxxxxxxx.xxx
> www.cambridgebroadband.com
>
> If you don't live life on the edge, you're taking up too much space.
>
>
> To change subscription see www.landrover.net/series1/mail
>


To change subscription see www.landrover.net/series1/mail